Electrical connection

After verifying whether a device is complete, you can switch to the connection.

For connection you will need:

  • An Ethernet UTP CATCAT5 or higher cable connected to a network switch/router. 

Cable length recommendations

The maximum length of the UTP CAT5 cable segment should not exceed 100 meters, according to the IEEE 802.3 standard. The standard 

  • Power supply at + 12V, 2 amps if there is no PoE.
  • Wires must be brought for connecting the additional modules (optional).

Here are typical connection schemes:

Connection using the siren output as a controlled output with an external additional relay, to control devices or any other load with high power consumption 


Connection using various types of buttons connected to alarm loops, and using them as bell buttons 


Connection of security alarm sensors with NC (normally closed) contact types 


Connection of security alarm sensors with NO (normally open) contact types 


Connection of security alarm sensors with NC (normally closed) contact types using SH-16 module


Connection of security alarm sensors with NO (normally open) contact types using SH-16 module